Shaun88.19

My hair brained scheme to route whatever water leaks behind the windscreen rubber out may work, or not, time will tell. I am definitely n...

After much back and forth, test fitting and finally some paint, the bottom has a decent coat on, I managed to get something welded in pla...

I had some small details to finish before welding in the patch under the windscreen cowl. There was a tiny hole to patch and I marked the...

As is probably expected the part I cut out warped a bit and does not fit back in position perfectly. I picked up some of these, they are ...

With the rough shape I started refining it until finally I could get the piece I cut out to fit over it. It took quite a bit of back and ...

I pondered a long on time on how to get started with this piece. Eventually I just took the bits I had cut out and used them as a guide a...

Not an lot of change visually but I did spent quite some time welding in thin strips to replace the rusted edges that I had cut off / bac...

Cutting out rust from the inner layer meant I could now see through and into the cab... I chased down the last bit of rust into the engin...

I tried cutting away the least amount of metal, so that replacing it would be somewhat simple, unfortunately I found more rust after I cu...

It took a while but I finally managed to gather up the courage to cut a large hole in what, on the surface, looks to be good steel. It's ...