Earthing for the Solar Inverter that I installed in the past few days 😮

Well hello there everyone 😀
😅..what a tough day to write a post about my progress 😁 but I don't mind because I will present my reports that I did not post day by day.

So about the progress,I did the earthing the past few days ago.Man that was painful ,so about this as usual I go to the work, attended the meeting and divided the assignments that we are going to do and departed our workshop separately after we finished meeting.So this time I got the Earthing I don't know what you guys called it) but we called that as Earthing,I explained that in my previous post,I think I don't need to explain to you guys again.

So when we arrived at the house that we are going to work,we dropped off and prepared to do our things.Like checking the place where it will be put and where it can be dig.After confirming the area,we start to strike and here is the worst part of it.Man the ground it was so hard that it didn't even budge with our brick breaker gun.So we have to think the another way around how it can be dig.And then we come to an idea, we have to break the floor with using our 12 pounds massive hammer.Ohhh....lord have mercy,I want to cry 😭 when we break that thing,it was so freaking hard that our hands start to numb and shaking and yes we did take turns.But how can it be last ,we don't give up and breaking the floor continuously and it starts to crack,so we grab the gun and start digging the hole.

Digging the hole was easy because once we break the thing when we use the gun ,it went straight digging and didn't even need to use our forces.After that we grabbed the earth rods and hammers it to the hole that we dug earlier and after that I tested the earth results.Ouff...it was a fantastic result,I thought at the same time our hard work pay off.So after that I join the earth cable to the rod and tested the solar earth voltage and of course it has zero because we just finished joining the earth cable to the earth rod.So whoever touched the inverter,no one is going to electrocuted because of the things that we did.So yeah it was used for the safety after finish installing the solar structure, solar panel or even solar inverter.So thats why we have to do the earthing after installing the solar panels because the voltage that come from the solar will electrocute you (don't worry small amount of it)it can't hurt the people but when you touch it 😁 you qill feel a little bit of tingling 😅 so that why we have to put that voltage off to the ground,so no one will feel that tingling sensation when we touch the inverter or the devices that are installed together.After we done ,we checked all the installation and of the earthing that we done earlier and take some photos of it and went back to ur workshop.So yeah that was the process that we done in the past days and of course I will show you some of the photos of it.

The place where we put our earth rods and earth test box.

And this is the earth results after testing it.
I hope you guys like about the progress that I have made.
And also if my spelling or bad writing please forgive me,I don't familiar with English but I learning how can I speak and write with English properly,so hope you don't mind 😁
Anyway have a great day 😀 See you next day 👋